There is a few of important things to check here:
* The `output` identifier matches the identifier of the UTXO you are going to send
* The `offset` of the inscription is `0` (this means that the inscription is located on the first sat in the UTXO)
* the `output_value` has enough sats to cover the transaction fee (postage) for sending the transaction. The exact amount you will need depends on the fee rate you will select for the transaction
If all of the above are true for your inscription, it should be safe for you to send it using the method below.
⚠️⚠️ Be very careful sending your inscription particularly if the `offset` value is not `0`. It is not recommended to use this method if that is the case, as doing so you could accidentally send your inscription to a bitcoin miner unless you know what you are doing.
#### Sending your inscription
To send an inscription navigate to the `UTXOs` tab, and find the UTXO which you previously validated contains your inscription.
If you previously froze the UXTO you will need to right-click on it and unfreeze it.